PROFI CONSULTING
from 9am to 5pm
No products
*281 895
FORGE bar and plate intercooler for the Hyundai Veloster N Facelift, including DCT models. It has 129% more volume and 71% more frontal area than the stock cooler, and the kit includes a 64 mm boost pipe.
New product
FMINT31
Add to wishlist In your list · view

FORGE intercooler for Hyundai Veloster N Facelift (including DCT)
FORGE bar and plate intercooler for the Hyundai Veloster N Facelift, including DCT models. It has 129% more volume and 71% more frontal area than the stock cooler, and the kit includes a 64 mm boost pipe.
Send the question to the owner of the store, about this product.
* Required fields
or Cancel

FORGE intercooler for Hyundai Veloster N Facelift (including DCT)
To be informed about product update via email, fill out the form.
* Required
or Cancel
FORGE bar and plate intercooler for the Hyundai Veloster N Facelift, including DCT models. It has 129% more volume and 71% more frontal area than the stock cooler, and the kit includes a 64 mm boost pipe.
The FORGE intercooler for the Hyundai Veloster N Facelift, including DCT models, is intended for cars used for fast road driving or with a high level of tune in a hot climate. It uses a bar and plate core and cast end tanks designed in CAD with flow simulation (CFD). The turbo side end tank has an internal divider that ensures the full volume of the stepped core is used. Compared with the stock cooler, the core has over 129% more volume and over 71% more frontal area. The intercooler has fabricated ducting that follows the inner contour of the front bumper.
The inlet and outlet are 65 mm in diameter, giving 27% more volume than stock. The kit also includes a hot side boost pipe that replaces the factory pipe. Its diameter is 64 mm instead of the original 50 mm. The intercooler and boost pipe are finished in a black textured powder coat. The bar and plate core was chosen after testing several core designs and has minimal pressure drop.
For testing, the car was heat soaked on the dyno until the radiator fans cycled on and off. This gives an inlet temperature of around 40°C. After more than six pulls on the dyno, the inlet air temperature (IAT) with the FORGE intercooler was 24°C. The stock intercooler reached 48°C. The ambient temperature in the dyno cell was 15°C.
The kit includes all the necessary hardware. Installation takes approximately 2.5 hours, depending on competency and the tools available.
This discussion is especially meant for information exchange between customers. For questions regarding your order or stock availability, please contact us directly.
| Make | Model | Generation |
|---|---|---|
| Hyundai | Veloster N |
No manufacturer found
