PROFI CONSULTING
from 9am to 5pm
No products
*61 889
New product
4021RC6
RC6 - Snow, wet, gravel races or rear axle
Average friction coefficient µ= 0,4.
CL brakes original compound, RC6 was designed to apply to a wide range of motorsports, from rally to circuit. It has a high and very flat friction level and can be used successfully in almost every type of race car. Low compressibility provides a stiff pedal which greatly increases feedback and allows for easier modulation. It can also be used in the front or rear axle combined with the RC8 or RC5 to adjust bias.
Application:
VOLKSWAGEN Golf (1) , 1.6 GTI 75→83 (front pads)
VOLKSWAGEN Golf (1) , 1.8 GTI 75→83 (front pads)
VOLKSWAGEN Golf (2) , 1.8 GT 86→91 (front pads)
VOLKSWAGEN Golf (2) , 1.8 GTI 86→91 (front pads)
VOLKSWAGEN Golf (2) , 1.8 GTI 16V 85→86 (front pads)
VOLKSWAGEN Golf (2) , 1.8 GTI G60 16V 83→88 (front pads)
VOLKSWAGEN Jetta (2) , 1.8 GT 84→92 (front pads)
VOLKSWAGEN Jetta (2) , 1.8 GT 16V 84→88 (front pads)
VOLKSWAGEN Polo (2) , 1.3 G40 91→94 (front pads)
VOLKSWAGEN Polo (2) , 1.3 GT 90→94 (front pads)
VOLKSWAGEN Polo (3) , 1.4 16V 95→97 (front pads)
VOLKSWAGEN Scirocco (1) , 1.6 GTI 79→81 (front pads)
VOLKSWAGEN Scirocco (2) , 1.6 GTI 81→83 (front pads)
VOLKSWAGEN Scirocco (2) , 1.8 GL 83→84 (front pads)
VOLKSWAGEN Scirocco (2) , 1.8 GTI 83→84 (front pads)
VOLKSWAGEN Scirocco (2) , 1.8i Scala 16V 89→91 (front pads)
CL Brakes (previously Carbone Lorraine) created in 1919, roup is the main actor in integrated on-board railway systems with more than 4500 employees and more than 30 sites over the world. Now called "Faiveley Transport Gennevilliers" and owner of the brand CL BRAKES, the Brake Pads Department retains the manufacturing activity for its sintered metal brake pads in its historical site of Gennevilliers, France, benefiting from a common know-how in R&D acquired in aeronautic as well as in rail activities, and thus allowing a constant improvement of our materials for cars, motorcycles and mountain bikes. Sintered metal brake pads are made based on powders. The friction product contains at least ten ingredients (Bronze, ceramics, graphites...). Each of these ingredients makes the friction mixture, which is then compressed in a device that will give it its final shape. The obtained item is then positionned on its metal support and then heated in a 900+°C oven. It's the sintering process : a constituent of the product melts, consolidates the material and makes it fuse with its support. The brake pad is then rectified, checked and packed.
This discussion is especially meant for information exchange between customers. For questions regarding your order or stock availability, please contact us directly.
CL Brakes pads Set. VOLKSWAGEN