Brake pads CL Brakes 5001W43T14RC8

RC8:  RRC, TWCC, Nascar, 

Average friction compound: µ=0,6.

Developed in 2006, the RC8 compound boasts CL Brakes highest friction level and is used in top-tier motorsports such as WRC, WTCC, NASCAR, ZA V8, AWD GrpN, etc. Extremely high friction levels allow shorter stopping distances and the flat torque curve provides excellent modulation to prevent wheel lockup.

The RC8 was designed to be used only with other CL Brakes compounds.

Application:

MINI 1275 , GT 69→74 (front pads)

MINI Cooper , S 1275 63→71 (front pads)

ROVER Mini , 1.3 Cooper S 63→71 (front pads)

AUDI TT, Cup 15-→ (rear pads)

CATERHAM , (AP Racing) 97-→ (rear pads)

HONDA Civic, TCR 15-→ (rear pads)

MORGAN Aero 8 , 4.4 00-→ (rear pads)

MORGAN Aero 8 , 4.6 04-→ (rear pads)

OPEL Astra , OPC 15-→ (rear pads)

PEUGEOT 306 , Kit Car Gr. A Rallye →-95 (rear pads)

SEAT Leon, Cup Racer MK3 14-→ (rear pads)

TVR Cerbera , 4.0 (Speed Six) 98→01 (rear pads)

TVR Cerbera, 4.2 94→01 (rear pads)

TVR Cerbera, 4.5 97→01 (rear pads)

TVR Cerbera, 5.0 94→98 (rear pads)

TVR S , 96→94 (rear pads)

VAUXHALL Carlton , 3.6 Lotus 24V 90→94 (rear pads)

VOLKSWAGEN Golf (7) , TCR 15-→ (rear pads)

CL Brakes (previously Carbone Lorraine) created in 1919, roup is the main actor in integrated on-board railway systems with more than 4500 employees and more than 30 sites over the world. Now called "Faiveley Transport Gennevilliers" and owner of the brand CL BRAKES, the Brake Pads Department retains the manufacturing activity for its sintered metal brake pads in its historical site of Gennevilliers, France, benefiting from a common know-how in R&D acquired in aeronautic as well as in rail activities, and thus allowing a constant improvement of our materials for cars, motorcycles and mountain bikes. Sintered metal brake pads are made based on powders. The friction product contains at least ten ingredients (Bronze, ceramics, graphites...). Each of these ingredients makes the friction mixture, which is then compressed in a device that will give it its final shape. The obtained item is then positionned on its metal support and then heated in a 900+°C oven. It's the sintering process : a constituent of the product melts, consolidates the material and makes it fuse with its support. The brake pad is then rectified, checked and packed.