Carbody spray film, black mat, 5L

FOLIATEC is one of the first producers who offers metallic colours which are ready to spray. Ready to use for spray nozzles between 2.0 and 2.5 mm the Carbody Spray Film can be applied like a normal lacquer on car bodies by using a spray gun or our FOLIATEC Spray System.

The applicated coating can be removed easily anytime without any helping tool.

• ready to use
• sufficient for partial coating of automobiles and full coating of two-wheeled vehicles
• very good opacity
• appealing appearance and a smooth spray result
• protection from scratches, salt, weather conditions and stone chipping on the original paint
• UV resistant
• applicable on any non-absorbent surface
• easy to remove
• 1 litre is sufficient for a max. of approx. 2 sqm

Product tip: Optimal in combination with our Carbody Spray Film Thinner (Ref. Foliatec-20859) to adjust the viscosity.

Application:

• All car parts that can be easily removed should be dismantled. Mask all surfaces that are not to be coated. Mask rubber seals with FOLIATEC.com Easy Up Tape (item no. 79920). You should also protect wheel housings and the car underbody from spray mist.
• Clean and dry the surface to be sprayed, including edges, then degrease using FOLIATEC.com Carbody Spray Film Pre-cleaner (item no. 79934). After cleaning, remove the remaining dust with a duster (item no. 79933).
• Application with FOLIATEC spray system: Apply the FOLIATEC Carbody Spray Film in 4 to 5 generous layers. On horizontal surfaces (roof or bonnet), work at a slow pace and at level 1 or 2; set the quantity control on the spray pistol grip to level IIII. On vertical surfaces, work at a medium pace and level 2. If necessary, reduce the quantity control on the spray pistol grip. Only use in suitable workshops and garages. Reduce ventilation if working in a spray booth.
• Application with spray gun: Apply the FOLIATEC Carbody Spray Film in 4 generous layers at medium speed. Use a 2 - 2.5 mm spray nozzle with approx. 2 bar pressure on the spray gun in a suitable spray booth.
• Flash off for 45 - 60 minutes after every spray coating until the wet surface is visibly matt dried.
  Please note: For effect colours, e.g. magic green-purple first apply at least two matt black coats; after approx. 45 - 60 minutes’ drying time, spray on at least two coats of the effect colour.

Notes for RAL colours: first apply at least two transparent coats; drying time between coats: 45 - 60 minutes; after at least 3 hours drying time, spray on at least two coats of the RAL colour.

Hardening: After 1 - 2 hours the Carbody Spray Film is dust-dry. After 24 hours the vehicle is ready to drive again.

For detailed information, check the instruction manual!